2021 Kverneland 6500F Base

2021 Kverneland 6500F

Kverneland 6500F is the specialist baler for heavy silage conditions. The bale chamber is formed by 18 ribbed profile rollers which ensure maximum bale density and superb bale rotation in all conditions, while power requirement is also kept to a minimum for more efficient operation.

• New 2.3m extra wide low profile pick-up equipped with twin cam tracks and five tine bars

• New SuperCut 15 knife pre-chopping system

• Parallelogram Drop Floor system for faster unblocking

• Fixed chamber with 18 ribbed rollers for high-density bales

• PowerBind net wrap system

• Simple and intuitive control with the Focus 3 terminal

Features may include:

New 2.3m extra-wide pick-up, designated ‘XL+’ incorporates an extensive series of upgrades:

• Equipped with five tine bars with 32 tines per bar

• Each tine bar is supported by four ball bearings along its length

• Twin easy access cam tracks located at both ends of the pick-up

• Large diameter roller crop press for increased intake speeds

• Innovative inboard driveline design for reduced transport width

New SuperCut 15 knife pre-chopping system provides higher efficiency and improved crop flow into the baler. Specially profiled knives have been developed to give a consistent chop length with a low power requirement. With a chop length of 70mm, it is the ideal solution for producing tight, dense bales, which result in improved fermentation, with the further benefit of easier feeding out of bales and less wastage.

Each knife is individually spring protected against foreign obstacles, giving a higher level of protection than systems that protect only the complete knife bank.

The SuperCut 15 intake system is equipped with the super effective Parallelogram drop floor system, which brings faster and easier clearing of blockages. The system not only lowers the rear edge of the drop floor as per traditional systems but also lowers the front section of the floor, where a blockage is more likely to occur.

Kverneland 6500F is equipped with the patented front mounted PowerBind net system. PowerBind eliminates troublesome feed rollers and has market leading cycle time.

The net is continuously retained in the PowerBind injection arm. When the bale is 90% complete the arm moves forward ready for the net injection.

When the bale is 100% complete net is fed directly onto the bale in a flat movement angle keeping the net tight at all times, providing accurate and extremely reliable net injection. PowerBind gives you the confidence of doing a professional job, without influence from wind or crop build-up.

PowerBind offers very low loading height for maximum convenience and time-saving. To replace the empty roll just swing out the shaft and slide on a new roll.

The Kverneland 6500F is the specialist baler for heavy silage conditions. The PowerMax bale chamber incorporates 18 heavy duty rollers arranged in a perfect circle for maximum bale rotation capability in all conditions. This is the ideal solution for producing well shaped and dense bales.